James Russell BSc (Eng) MIEI CEng
157 Shore Road
028 93 35 35 86
028 93 37 22 22
07715 32 42 54
07715 32 42 53
This sheet is an outline of general information for those considering piled foundations for industrial units and has been prepared in good faith. It should not be used as a replacement for expert analysis of individual situations.
All work is carried out above ground level and generally requires less preparation than is required for conventional piling machinery.
Advantages of the driven piling method we use for pile installation include:
> No spoil production and hence no material to remove from the site
> We use no wet materials; hence it is a clean operation, no need for wet concrete
> All our piling machines are much smaller than conventional machines, enabling us to pile very close to and inside existing buildings
Conventional piling (Low vibration)
250 x 250mm Square RC sections capable of 160.0 T (UL)
200 x 200mm “ “ “ “ “ 100.0 “ “
Mini-Piling (Very low vibration)
220mm Ø Pre-filled steel tubes “ “ 84.6 “ “
168mm Ø Pre-filled steel tubes “ “ 49.3 “ “
150mm Ø Pre-filled steel tubes “ “ 43.6 “ “
Monitoring for sites where excessive vibration could pose a problem to existing adjacent structures
Precast Ground Beams
We can design, supply and fix complete ground beam* solutions for domestic and industrial applications. We can also provide for precast floor units, negating the need for in-situ ground work.
*These beams use full moment connections and provisions can be made for irregular floor plans, meaning fewer restrictions on the client.
If you have any questions regarding the information found on the website, please feel free to get in touch via one of the methods shown on the left.